Asosiasi Pengelasan Indonesia (API)

Summary – The Basic Steps in Interpreting a Radiograph

1. Verify that the radiograph corresponds to the part being examined.
2. Verify that radiographic coverage is complete for the particular part.
3. Verify that the image quality indicators are correct and properly used and that the proper image quality level was achieved.
4. Verify that the film densities meet requirements of the standard.
5. Check for film artifacts and indications of surface phenomena and record anyon the viewing record
6. Retake any indications that cannot be resolved as an artifact or discontinuity.
7. Visually check the surfaces of the part for surface discontinuities or contours that match the appearance of the discontinuity on the radiograph.
8. Evaluate the internal discontinuities to the applicable standards and accept, reject, or hold the part for further review. Record as ‘complies’ or ‘does not comply’ on the viewing record.
9. Mark the locations on the part of any non-complying discontinuities.
10. Prepare a test report indicating the nature, extent, and disposition of all significant indications found on the radiographs.